If the cord in the curtain rod breaks or becomes damaged the curtains will be stuck in one position.
Curtain track cord repair.
100 pieces clear roman curtain rings blind roman ring and 55 yards roman blind cord 8 13 mm transparent plastic rings 1 8 mm white braided lift shade cord for diy roman curtains 4 8 out of 5 stars 15 9 99 9.
Take the rod assembly off the brackets and place it face down on a flat surface.
Re attach track onto brackets and re hang curtains.
Unhook the pull cord from the tension pulley next to the window.
Pull the cord from the rod cutting it free from any tangles.
Next place the rod face down on a flat surface.
You can fit new cord to curtain tracks to replace the damaged or broken cord in a matter of a.
Unscrew the brackets that hold the rod in place and take the rod down.
Place the rod with the hardware facing up and feed the new cord under the top pulley on the left end of the rod.
Tie off the cord ends at the master carrier and test the long loop of cord adjusting the cord.
Draw the cord until the right hand carrier 1 is as far to the right as possible.
First you ll want to remove the curtain along with the curtain hooks from the rod and carriers.
Hook cord over the lug on carrier 2 to secure it.
Pull cord through opposite end pulley by hooking cord position and pull through excess cord.
Lift the curtains out of the rod brackets and place on a table.
Holding the cords taut push carrier 2 as far to the left as possible.
How to fit new cord to curtain tracks take measurements.
Replace sliders at each end.
To change cord pull from left to right remove cord from tension pulley by sliding the pulley wheel toward the tension pulley body and removing the wheel.
Place pulley 2 onto track section and secure with screws.
For the purpose of show you how to change you track cord.
If you re removing an old cord you can untie it.
Maneuver the new cord into the rod s track and through the opening.
Pass cord back through ovelrap master slide.
Tension cord and tie off h note.