Unplug the water cooler and leave it in this condition for next 24 hours.
Crystal springs water cooler not cooling.
Having done that you should turn off the switches at the back of your water cooler.
Crystal springs can provide water filtration solutions so that you can enjoy great tasting coffee tea and other beverages.
Fresh tasting water that never runs out.
Drain any remaining water and wipe dry.
Water cooler not dispensing hot cold water it s room temperature option 1 check that your water cooler is plugged in at the wall socket and that the mains power is turned on a surprisingly common cause.
Water not hot or cold enough check to make sure dispenser is plugged in and the switch is turned on.
Plug your cooler back into the wall outlet but do not replace the jug just yet.
Place the bottle back on the dispenser.
If your water cooler is not chilling turn it off and make sure it powers up the compressor may take a few minutes to start after a power up.
Water tastes bad dispenser may need to be cleaned see cleaning and sanitizing.
In some units the waste heat from the compressor is used which can explain why you re not getting either hot or cold.
Instead locate the switch at the back.
Remove bottle from dispenser.
If you are getting cold water not hot then the heater unit is burnt.
Turn it off unplug your cooler once more and leave it unplugged overnight.
Cold brew brazilian 180 mg can triple draft latte 175 mg can vanilla draft latte 115 mg can.
Dispense two cups of water.
Remove the water bottle from the cooler.
This will also serve as the reset switch.
Use a small plastic container to bail out the water in the well of the cooler.
When most of the water has been bailed out use a sponge and bucket to soak up residual water.
It could be out of freon or the compressor its self is shot.
This may be the result of a hairline crack in the bottle which alters the pressure within the cooler from the normal vacuum.
Get information on your crystal springs water cooler including equipment starter videos quick setup guides and user manuals.
Also check that the power cable at the back of the unit is firmly pushed into its socket.
99 of the time water cooler leaks are the result of a leaking water bottle and not from the cooler itself.