Pull the rope and after a few pulls it started than died.
Craftsman 2800 pressure washer won t start.
7 possible causes and potential solutions.
4 possible causes and potential solutions.
Now it won t start.
The engine won t start if the engine is out of fuel or if the fuel is stale or contaminated with water.
Fuel in the tank.
Hold the bottom of the spark plug to a clean area on the engine block.
This 2800 max psi at 1 8 gpm 2 3 max gpm at 300 psi gas pressure washer powered by a reliable briggs stratton engine provides all the power you need to tackle your everyday residential cleaning tasks.
When the engine doesn t start first make sure the rocker switch that controls the engine is in the on position.
Common symptoms 6 related videos 9 pressure washer won t start.
If it still doesn t try to start remove the spark plug and connect the ignition wire to the spark plug.
My craftsman pressure washer will not start it is one year old and stored inside i changes the spark plug and replaced the gas still nothing pulled off the air filter and sprayed some starting fluid in and on first pull it started then failed added in some carb and choke cleaner sprayed in same place did this three times but no avail thinking i have to change or clean.
Replace the fuel in the gas tank if the fuel is older than 3 months.
Get more specific information by entering your model number.
Even if it s not running turn the switch to the off position.
Do you have fuel in the tank.
First check the on off switch to see if it is in the on position.
Craftsman pressure washer repair help.
This sticky fuel can clog up the carburetor and prevent the engine from starting.
The carburetor might be clogged.
If your gas powered pressure washer engine does not start or is lacking power there are a few things you can do.
I was going to use it i put gas in and oil hooked up water hose.
Next check the fuel.
A clogged carburetor is most commonly caused by leaving fuel in the pressure washer for a long period of time.
Featuring the readystart engine starting system the unit will start within two pulls or an authorized briggs stratton service center will fix it for free.
If so is the shut off valve open and the fuel clean.
Bad fuel can contaminate the carburetor.
However before you touch anything turn the engine off.
Need help finding your model number.
Try to start the engine again.
Over time some of the ingredients in the fuel may evaporate leaving behind a thicker stickier substance.